Hydraulic rising bollards are designed especially for high security vehicle entrances and for a location that has to be closed for motorized traffic on specific times. They can be installed as a single unit as well as in groups. Bollards are driven hydraulically and the hydraulic drive unit is placed in an installation cabinet close to the bollards. In case of power failure bollards can be lowered manually. With the help of plc/microprocessor controlled electronics, raise/lower function can be achieved by every kind of card readers, biometric readers like fingerprint or hand shape, radio control, on/off switch or key switch etc. Besides, safety accessories like loop detectors, photocells, flashing lights or red/green lights can be integrated to the control electronics very easily.
Product Details:
Speed | 2 -3 Secs. |
Height | 700 mm |
Diameter | 225 mm |
Thickness | 12 mm |
Power Supply | 5-6 ATM air pressure 110-240V AC (Compressor) |
Operating Temperature | -20 to 60 degree centigrade |
We are leading manufacturers of Pneumatic Bollard.
Operated either pneumatically or hydraulically, the B3000 series offers the highest standard of anti-ramming and security protection. Taking as little as 2 seconds to reach the fully raised position, these bollards can be used in the most demanding locations where high-volume traffic flows must be managed. The B3000 bollards are often combined with light arm barriers to providing maximum deterrence and safety. With a hard-wearing stainless steel finish, the bollards are engineered to meet the DOS and PAS standards for anti-ramming and are used extensively to protect sensitive government and military locations as well as civilian compounds.
Product Details:
Material | SS,n/a |
Usage/Application | n/a |
Power Supply | 230V |
Available Rating | K4 / K8 / K12 |
Time Required | 2 seconds |
Product Series | B3000 |
Hydraulic Bollard is designed especially for high security vehicle entrances and for a location that has to be closed for motorized traffic at specific times. They can be installed as a single unit as well as in groups. Bollards are driven hydraulically and the hydraulic drive unit is placed in an installation cabinet close to the bollards. In case of power, failure bollards can be lowered manually. With the help of plc/microprocessor controlled electronics, raise/lower function can be achieved by every kind of card readers, biometric readers like fingerprint or hand shape, radio control, on/off switch or key switch etc. Besides, safety accessories like loop detectors, photocells, flashing lights or red/green lights can be integrated into the control electronics very easily.